Recent content by xxchieferxx

Pmd

Still making these? Fit 52mm gauges? I'm in Kentucky

Is this the ford kit M-4210-B3?

Bump

72lb (800cc) injectors that came with my whipple kit. They only seen 93 octane gas through them and never had a single issue with them. The pictures have information as to what vehicles they fit. They also fit s550 mustangs that have the whipple fuel rails as well. These can be shipped on...

So I have bmr bk049 and my driveshaft/front side bolts have bent. Has anyone had good luck with the bk050 (billet aluminum) bushings with not getting bent bolts? Trying to determine if doing the bk050 will cure this problem or if there is another solution. Whipple 700whp Bc stage 3 mt82 Full...

Lol thats me. They probley the 1st version since I bought them when they first came out.

I had the same issue as you op. I just pulled mine off and took all the tape off of it. Anyone want to buy an rtr gurney flap? It just needs 3m tape applied to it

Pmd

Where are you located?

Did this sell?

I guess nobody else is having problems. They wont work with my vsforged wheels or the weld rts71 with my et street r 28-11.5-17.

Anyone having issues with rubbing even after the smaller washer installed? 19x11.5 rears et 56 -1degree of camber.

I would like it please. You in Maryland? Paypal?

Is the 3.625 still available?