Steeda's S550 Mustang Billet Rear Spring Spacer 1/4" & 3/8” - Now Available!

BoostedRubyRed said:

I was going to have my dealer install these while getting some warranty work done and they want 4 hours labor, is it just me or does that sound excessive?

Click to expand...

4hrs to install the spring spacers? It should be an hour or so. That is how long it took Steeda to install mine.

For what they want to do the install I can drive to Atlanta and have Steeda do the install and spend the weekend visiting my brother and still have left over money

BoostedRubyRed said:

I was going to have my dealer install these while getting some warranty work done and they want 4 hours labor, is it just me or does that sound excessive?

Click to expand...

Yes. It should only be ~1 hr tops, maybe just a tad more because you have to disassemble parts of the CB005 to drop the cradle low enough. 4 is definitely excessive, though.

SteedaTech said:

Almost double the thickness of the spacer chosen. They will work with all Aftermarket and production Springs for the S550

Click to expand...

You need to add this to the parts description on your webpage. Otherwise many of your customers will forget about the multiplying effect of the rear motion ratio.

3/8" x2 is too much for my setup with Ford Racing Track suspension.

Grintch said:

You need to add this to the parts description on your webpage. Otherwise many of your customers will forget about the multiplying effect of the rear motion ratio.

3/8" x2 is too much for my setup with Ford Racing Track suspension.

Click to expand...

Thank you!

SteedaTech said:

Thank you!

Click to expand...

New 1/8 inch spacers now available.

https://www.steeda.com/steeda-s550-mustang-billet-rear-spring-spacer-1-8.html

Front end

Any plans for a front spacer?

I guess to fit on top of the shock... it looks like there is enough thread under the hood.

SidewaysMike said:

Any plans for a front spacer?

I guess to fit on top of the shock... it looks like there is enough thread under the hood.

Click to expand...

They will be available next week, in 1/4 and 1/2 inch increases

Thank you, Mike D

Sweet!

Bump for fronts too. Undecided right now on the back if i should go with 1/4 or 3/8 spacers. Have sportline and they measure 27 1/8 from the rear inner fender fronts the same but looks like its racked backwards. Want the rear up .75" will be interesting

https://www.steeda.com/Steeda-S550-Mustang-Front-Ride-Height-Spacer-Kit-2015-2019_p_12604.html

Not sure if you were looking for the link for the fronts.

TJ

Very interesting, just ordered the rears from you guys last night. Assuming the fronts just go under the stock plates?

You can check out the install instructions here - https://www.steeda.com/assets/images/documents/555-8254.pdf

Hum, I currently have (didn't intallmyself) Maxium Motorsports caster camber plates, not sure how this will effect it.

By looking at my setup, hypothetical wondering if someone could just install one of these plates over installing the whole kit with longer screws.

tj@steeda said:

You can check out the install instructions here - https://www.steeda.com/assets/images/documents/555-8254.pdf

Click to expand...

Am I to understand that you're replacing the three strut mount attachment studs with longer studs or perhaps bolts? The directions aren't clear on whether you're replacing or reusing this OE hardware.


Norm