Help! broken connector while removing valve covers

I managed to get too enthusiastic with this connector whiel taking my valve covers off, and have pulled the wires from the plug.
I have a soldering iron, and some picks/screwdrivers to fix it with,
but am not sure where to start.
Can anyone point me in the right direction?
Also, I need to verify the colors -can anyone verify which goes where?

Thanks!
Pete

Not sure which wire your talking about. Plug sensor for cam or ignition coil plug. I know they sell new plugs for injectors and ignition coil plugs, just don't know about the cam position sensor plug.

I attached pictures, but they disappeared from the post

https://i.imgur.com/haYb45c.jpg
https://i.imgur.com/7qQvSpg.jpg
https://i.imgur.com/VPQznGe.jpg

I really need to get on the road by tomorrow, and was hoping to fix, and replace later - I do have some dsub pins and a crimper - possibly cold jam then into the plug, but an unsure of which color goes to which pin..

Back right side of the motor. I'll check and let you know

Ok so the Dark brown green strip goes to the right in the back. If your looking from the front on your first posted picture it's on the left or bottom.

Thanks Kahboom - So far that's the only connector I've managed to break during teardown for OPG install.
Should be back on the road tomorrow!

good news, glad I could help.