Must_Tang
Well-Known Member
- Thread starter
- #1
So, I was running at Palmer yesterday with an ambient of about 80-85. The second session out and a few laps in, my car started to cut power, very drastically, where it was totally dead above approximately 3k rpm. Limp mode.
CHT was good, about 235, oil temp was about 220.
I have a Mishi radiator and oil cooler with the gauge reading the cold side of the sandwich plate.
I had the center display reading so CHT is on the top and AT temp is at the bottom.
AT temp was 250F when the power cut happened. Subsequent runs had the same thing happen at 250F. This is about 15 mins into a 20 minute run. This was the first time this happened on the track; I've been running this all year, though this was hottest ambient temp it has been.
Does anyone know if 250F is the point where it goes into limp mode? It sure seems like it is.
There was no warning message on the display and there was no code thrown.
Looks like it is time for a Mishi trans cooler.
CHT was good, about 235, oil temp was about 220.
I have a Mishi radiator and oil cooler with the gauge reading the cold side of the sandwich plate.
I had the center display reading so CHT is on the top and AT temp is at the bottom.
AT temp was 250F when the power cut happened. Subsequent runs had the same thing happen at 250F. This is about 15 mins into a 20 minute run. This was the first time this happened on the track; I've been running this all year, though this was hottest ambient temp it has been.
Does anyone know if 250F is the point where it goes into limp mode? It sure seems like it is.
There was no warning message on the display and there was no code thrown.
Looks like it is time for a Mishi trans cooler.
Sponsored