It won't work. You will get a oss warning light.The OP wired it without using a speed sensor box. I'm trying to do the same as well. Just need to find out which wires where used
Agreed. You'll also get some issues where the RPMs hang when shiftingIt won't work. You will get a oss warning light.
I'm not sure what Lund did on his end, those are the setting to allow the computer to read everything properly. If you choose to not run a calibration box, you will get OSS sensor warning codes. GT500 and 5.0 aren't the same.Question on the Dakota Digital box...are these settings something that can be done in the tune or through the obd2 calibration tool? Or is this because of the two wire different sensor itself? Seems like if this was a stock transmission for this vehicle the tune should be able to be configured to what it is in the GT500.
Also what needs to be done for the throw out bearing, slave, etc? Does the stock MT82 stuff work?
Nice to see another TR6060 joining the club (I am in the shuffle).
Where did you source yours from?